Innokin Podin Replacement Pod
Innokin’s innovative Podin pod system gives a vape similar to a cigarette - “ideal for those switching from smoking to vaping”.
The Podin replacement pod is a 2ml re-usable pod with a 1.3 ohm kanthal coil that fits onto the top Innokin Podin mod. This popular and tiny pod has many innovative features that provide high resistance with low-wattage for MTL vapers.
Frequently bought together
- Price is for 1 pod
- This pod is only compatible with Podin pod/kit
- Kanthal 1.3ohm coil
Either the whole pod can be replaced with a new one, or just the coil in the pod can be changed. The latter is a more cost-effective alternative to the whole pod having to be thrown away. You do not need to replace the pod unless it is faulty; just throw the old coil out and replace with a new one.
Another top feature is the airflow control knob. This is a tiny wheel-like lever on the front of the unit, which enables vapers to adjust the airflow.
Filling the pod
The Podin uses an 800mAh battery that lasts a day with moderate use. After charging the battery, which is housed in the mod, remove the pod from the mod to fill.
Peel back the blue silicone stopper on the side of the pod and pour in the juice. Once the pod is full, refit the stopper and re-install the pod onto the Podin mod.
With the low battery wattage, this pod enables your juice to last longer. A 60ml bottle of e-juice can last more than month in a pod system.
The highly favoured kanthal coils produce consistent good flavours and thick clouds.
Remove the coil from the pod by rotating the base of the pod counter-clockwise. The coil is fastened on the base.
Drip about three or four drops of juice inside the coil to prime to the coil. Ensure the O-ring is fitted, then replace the base on the pod and rotate clockwise.
Wait a few minutes before vaping to saturate the wick first. When replacing coils ensure the coil is fastened on tightly.
The inexpensive coils are so tiny they have a short life span. But the vapour production is excellent, while flavour quality and cloud density are consistent.
Before placing the pod back in the mod, you can set your airflow using the knob at the side of the pod near the base.